|
|
|
Categories
|
|
Information
|
|
Featured Product
|
|
|
 |
|
|
There are currently no product reviews.
 ;
It took about 24-hours after my payment before I was able to get to the download. Apparently, payment processing is not 100% automated. That is no big deal, just be aware of that going in.
After I got to it, it was in good shape, easy to read, etc. Not some cheap FAX copy looking thing.
Also, this site was the cheapest I found. Another Plus!
 ;
Good price, very legible manual, exactly what I needed -- but had to wait a day to actually get the download of the manual. Would have preferred to download it immediately after payment rather than waiting for someone to "process" my order. I was surprised that I had to wait that long.
;
As the only source for this manual it rather rank quite high since it is well scanned and perfectly readable.
;
the manual is in good quality and it's in pdf. manual was send in less then 24h.
regards
mike
;
I would not plug this machine in without finding a manual like this. In addition to setup and normal operating instructions, it has troubleshooting flowcharts, diagrammed mechanical adjustments, and schematics to beat the band. The tech I hand it to would be thrilled to find solder side PCB diagrams with component outlines superimposed, pinouts for every IC chip, and line drawings of transistors, with labeled legs.
As for printing quality, this may be a copy of a copy, but even the finest print when enlarged is very legible. There is a bit of grayed print over a few pages, as if a wet page were placed over it, but the print is still very legible. If you could borrow an original manual and get it printed and bound for 4 to 6 times the cost, you could get better quality. In that case you wouldn't be here. For price, utility, and availability I am rating this manual highly.
NO WATER SUPPLY
Is the water supply shut-off?
NO
Is the tap opened?
NO YES
Open the tap.
When you press both Wash button and Rinse buttons simultaneously, is the water level frequency below 40? NO Is the inlet valve filter clogged with impurity?
YES
Check the chamber (Air) and the tube clogged with impurity.
YES
Clean the filter.
NO
Is resistance of the inlet valve connector k? between 2 to 8
NO
Replace the inlet valve.
YES
Check the voltage between each terminal of inlet Valve is 220~240V. (Refer to 7-2 TEST MODE) Replace PWB assembly (Main).
NO
DETERGENT DOES NOT FLOW IN
Is water supplied?
NO YES
Refer to solution NO INLET
Wiring diagram
Are replaceptacles correctly connected to the terminals of inlet valve?
NO
Check the wiring on the dispenser. Put the detergent in the correct position
YES
SOFTENER MAIN PRE WASH WASH
Is detergent put in the correct compartment of the drawer?
NO
PRE+MAIN MAIN WASH : Detergent
YES
Is the detergent caked or hardened?
YES
Clean the drawer.
31
|
|
|
> |
|
